products

AMX NI-700 Boardroom Control

AMX Control Processor

Controller for all Boardrooms

R12000.00 excl. VAT

 

 

Overview:

The NI-700 unit is geared to meet the specific control and automation needs of a single room environment, in which both price and functionality are the driving requirements. The NI-700 is configured to control a limited number of video players, projectors, lights, thermostats, and other electronic equipment.

 

Application:

Ideal for single-room environments with a limited number of devices such as classrooms, conference rooms, hotel rooms and other applications.

 

Features:

  • Ultra-fast 304 MIPS processor
  • 2 Configurable RS-232 / RS-422 / RS-485 Serial Ports
  • 1 IR/Serial Port
  • 1 IR Receiver Port
  • 4 Digital I/O Channels
  • 1 Ethernet 10/100 Port
  • 1 AxLink Connector
  • 64 MB RAM
  • 32 MB Flash Memory
  • 512 KB Non-Volatile Memory
  • AMX Device Discovery enabled
  • JITC Compliant

FRONT PANEL COMPONENTS

Program Port
Configuration DIP Switch: Sets the communication parameters for the Program port
IR RX LED: Red LED lights when IR data is being received via the rear IR RX port
IR LED: Red LED lights during the transmission of IR or Serial data via the rear IR port
I/O LEDs: Four yellow LEDs light when the rear I/O channels 1 - 4 are active. LED indicator for each I/O port reflects the state of that particular port
Serial LEDs
LINK/ACT: Green LED lights when the Ethernet cable is connected and an active link is established. This LED also blinks when receiving Ethernet data packets
Status: Green LED lights when the Controller is programmed and communicating properly
Output: Red LED lights when the Controller transmits data, sets channels sends data strings, etc.
Input: Yellow LED lights when the Controller receives data from button pushes, strings, commands, channel levels, etc.
ID Pushbutton: Sets the NetLinx ID (Device only) assignment for the device
REAR PANEL CONNECTORS

RS-232/422/485 (Ports 1 & 2)
IR RX (Port 5)
Digital I/O (Port 4)
IR/Serial (Port 3)
AxLink LED
AxLink Port: 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to external control devices
Ethernet Port: RJ-45 port for 10/100 Mbps communication. LEDs show communication activity, connection status, speeds, and mode information: - SPD (speed) - Yellow LED lights On when the connection speed is 100 Mbps and turns Off when the speed is 10 Mbps. - L/A (link/activity) - Green LED lights On when the Ethernet cables are connected and terminated correctly, and blinks when receiving Ethernet data packets.
Power Port
ENVIRONMENTAL

Operating Temperature: 0° C (32° F) to 50° C (122° F)
Operating Humidity: 20% to 85% RH
Heat Dissipation (Typical): 11.5 BTU/hr
INCLUDED ACCESSORIES

2-pin 3.5 mm mini-Phoenix female PWR connector (41-5025)
4-pin 3.5 mm mini-Phoenix female connector (41-5047)
6-pin 3.5 mm mini-Phoenix female I/O connector (41-5063)
CC-NIRC IR Emitter